Xantech 78095 Installation Instructions

“plasma friendly” j-box infrared receiver

Table of Contents

Download this manual

PRODUCTION RELEASE PER ECO# 4100

BLACK

20# MEAD BOND, WHITE

NONE

FINAL PART AND FINISHED SIZED

ARTWORK TOLERANCE:

DRAWN

COG. ENGINEER

CHECKED

PRINTING

8.5" X 11"

✘

DATE

09/01/04

A. Orellana

DATE

corporation

TITLE

INSTRUCTIONS, 78095

SCALE

SIZE

1-1

FILE NAME

DRAWING NO.

REV.

08905035

Table of Contents

Need help?

Do you have a question about the 78095 and is the answer not in the manual?

Page 1 PRINTING BLACK 20# MEAD BOND, WHITE NONE 8.5" X 11" FINAL PART AND FINISHED SIZED ARTWORK TOLERANCE: ✘ DRAWN A. Orellana COG. ENGINEER CHECKED corporation TITLE INSTRUCTIONS, 78095 DATE 09/01/04 DATE SCALE DATE FILE NAME SIZE DRAWING NO. REV. 08905035...
Page 2 INTRODUCTION The 780-95 is designed to reject interference from Plasma Displays from entering the IR signal line. This IR Receiver mounts easily into a single gang, electrical J-Box and is supplied with mounting screws and comes with a Decorator-style insert, allowing the installer to use a Decorator-style wall cover plate.
Page 3 Power requirements: 12 volts DC @ 20mA INSTALLATION This unit is meant to be installed into a standard J-Box mounting box and interfaced to Xantech Connecting Blocks, such as the CB12, 789-44, 791-44, etc. CAUTION: The J-Box must NOT be shared with 120/240VAC circuits.
Page 4 Figure 3 - Typical System Layout using 780-95, 789-44, 781RG, and 283M Emitters ADVANCED WIRING CONFIGURATION 780-95 may also be used in conjunction with other Xantech IR Receivers by simply wiring in parallel on a Connecting Block such as the 791-44 Amplified Block as shown in Figure 4 below.
Page 5 In Single Zone systems, the Status LED could show the ON/OFF status of an AV Receiver. To achieve this, simply plug a 12vDC adapter, such as the Xantech 786-00 Power Supply, into the switched AC Outlet of the AV Receiver. The 12v ‘+’ and ‘-’ leads are then connected between the STATUS (‘+’...