Table of Contents
Advertisement
N1010A FlexDCA and 86100A/B/C/D
Firmware Release Notes
CALibrate Subsystem Programming Commands
• :CALibrate:CHAN:ENABled (new)
• :CALibrate:CHAN:STATus (new)
• :CALibrate:CHAN:STATus:DETails (new)
• :CALibrate:CHAN:STATus:DTEMperature (new)
• :CALibrate:CHAN:STATus:TIME (new)
• :CALibrate:OUTPut (new)
• :CALibrate:SKEW:SLOT:STARt (new)
• :CALibrate:SKEW:SLOT:STATus? (new)
• :CALibrate:SKEW:SLOT:STATus:DETails? (new)
• :CALibrate:SKEW:SLOT:STATus:DTEMperature? (new)
• :CALibrate:SKEW:SLOT:STATus:TIME? (new)
:CHANnel Subsystem Programming Commands
• :CHANnel:BANDwidth:FREQuency (new)
• :CHANnel:FSELect:RATE (new)
• :CHANnel:PROBe (new)
• :CHANnel:WAVelength:VALue (new)
:CRECovery Subsystem Programming Commands
• :CRECovery:CFRequency? (new)
• :CRECovery:TDENsity? (new)
• :CRECovery:OUTPut:DMODe (new)
:DISPlay Subsystem Programming Commands
• :DISPlay:JITTer:GRAPh:TYPE (new)
• :DISPlay:JITTer:GRAPh? (deprecated)
• :DISPLay:MDISplay:DOCK (new)
:EMODules Subsystem Programming Commands (new)
The :EMODules extended modules subsystem controls the connection of extended and simu-
lated modules.
• :EMODules:CRECovery:SADDress (new)
• :EMODules:CRECovery:VADDress (new)
• :EMODules:REConnect (new)
• :EMODules:SIMulator:SRATe (new)
• :EMODules:SLOT:ADDRess (new)
• :EMODules:SLOT:CONNect (new)
• :EMODules:SLOT:DISConnect (new)
• :EMODules:SLOT:SELection (new)
• :EMODules:SLOT:STATe (new)
:PTIMebase Subsystem Programming Commands
• :PTIMebase:RIPRogress (deprecated)
:SIMulator Subsystem Programming Commands (deprecated)
• This entire subsystem has been deprecated. Use the :SOUR subsystem instead.
:SOURce Subsystem Programming Commands (new)
The new :SOURce subsystem configures the source signal of extended and simulated modules.
• :SOURce:AMPLitude (new)
• :SOURce:DIFFerential (new)
• :SOURce:DRATe (new)
8
Advertisement
Table of Contents
