Flow Of Post - NEC Express5800 320Fd-MR User Manual

Flow of POST

This section walks you through how POST is performed.
1.
When you power on the system, one selected CPU/IO module will start up.
POST will be performed on this selected CPU/IO module.
2.
Memory check starts.
A message appears at the upper left of the screen to show that the basic and expanded
memories are being counted. The memory check may take a few minutes to complete
depending on the server's memory size. Likewise, it may take about one minute for the
screen to appear when the server is rebooted.
3.
The server starts processor check, IO check, and initialization.
Several messages appear: they show the ID of the selected CPU/IO modules, information
on the processor, detection of the keyboard and mouse, etc.
4.
A message appears at the lower left of the screen, prompting for startup of the BIOS setup
utility "SETUP."
Press <F2> to enter SETUP
You will need to start it when you want to modify the configuration for using the server.
Unless this message appears together with an error message, you do not need to start the
utility to modify the configuration. (If you wait for a few seconds, POST will go on
automatically.)
To start the SETUP utility, press F2 while the above message is displayed. For setting and
parameter functions, see the section of BIOS setup.
When SETUP is completed, the server will reboot itself automatically and perform POST.
5.
A message will appear prompting for startup of Emulex BIOS configuration Utility. (If
you wait for a few seconds, POST will go on automatically.)
If you press Ctl + E or Alt + E, the Emulex BIOS configuration Utility will start.
However, you usually do not need to use the setup utility. For setting and parameter
functions, see Chapter 4 of User's Guide(Setup).
When SETUP is complete, the server will reboot automatically and perform POST from
the start again.
IMPORTANT:
If a message does not appear prompting for startup of Emulex BIOS configuration
Utility, correct the setting of Emulex BIOS. For details, see Chapter4 of User's Guide
(Setup).
6.
The screen shows the ID numbers of the connected disk drive.
7.
Upon completion of POST, the password entry screen appears prior to OS startup.
The password entry screen will appear after the normal termination of POST only if you
General Description 2-23