Clear Cmos/Password - NEC Express5800 320Fd-MR User Manual

4-36 System Configuration

CLEAR CMOS/PASSWORD

With the pre-installed SETUP utility, you can set desired passwords to protect data stored on the
server from unauthorized user access. If you forget the password, you can clear them by following
the procedure described in this section.
You can also use the same procedure to clear the CMOS data in the server.
IMPORTANT:

Clearing the CMOS data restores the factory settings.

To clear the password or CMOS data, power off the server.
To clear the password or the CMOS data, use configuration jumper pins (jumper switches) located
inside of the server. The jumper switches are found on the motherboard in a CPU/IO module. See
the figure below.
IMPORTANT:
Do not change any other jumper switch settings. Any improper change may cause the server to
fail or malfunction.
Use the clips
in J57
Pins for protecting
and clearing CMOS
contents
Pins for protecting and
clearing a password
Pins for protecting and clearing the BMC configuration