Safety Notices - NEC Express5800 1080Xd User Manual

Safety Notices

To avoid a risk of injuries, installation should be performed by trained technical
personnel.
It takes two to three people to unpack your server and two people to maneuver
the server, after unpacking. A tall rack is quite unstable, especially when not
fixed by stabilizers.
Your server is equipped with a front stabilizer. Engage the front stabilizer
during installation. For stability and to distribute the weight, also attach side
stabilizers or install two or more racks together. Otherwise, the rack may
topple over and cause injuries.
If you extend two or more devices from the rack at the same time, the rack may
topple over on you. Extend only one device from the rack at a time.
Exercise great care not to hurt your fingers on the rails when you
mount/dismount the equipment into/from the rack.
Elevated Operating Ambient Temperature – If installed in a closed or multi-unit
!
rack assembly, the operating ambient temperature of the rack environment may
be greater than the room ambient environment. Therefore, consideration should
be given to installing the equipment in an environment compatible with a
maximum rated ambient temperature of 35°C.
Reduced air Flow – Installation of the equipment in a rack should be such that
!
the amount of air flow required for safe operation of the equipment is not
compromised.
To prevent fires, and damage to rack equipment and supply wiring, make sure
!
that the rated load of the power branch circuit is not exceeded. Equipment
nameplate ratings should be used when addressing this concern. For more
information on installation and wiring of power-related facilities, contact your
electrician or local power company.
To prevent electrical shock, connect all rack and rack support equipment to the
!
same electrical circuit of the building wiring. If you are unsure, check the
building wiring to avoid remote earth conditions.
For safe operation, only connect the equipment to a building supply that is in
!
accordance with current wiring regulations in your country. In the USA those
wiring standards are regulated by Underwriter Laboratories (UL); in the U.K., by
the Institution of Electrical Engineers, (IEE) and in Canada by the Canadian
Standards Association (CSA).
2 Express5800/1080Xd/1160Xd/1320Xd Site Preparation Guide
!
WARNING