You must install drivers in order for Xponent to operate properly. Please consult the included Quick Start Guide for installation
Once the drivers are installed, you may need to conﬁgure your audio software to route signals to and from Xponent. Refer to your
program's user guide to learn how to do this.
While Xponent may look like a traditional DJ mixer with CD players attached to each side, keep in mind that nearly all of the controls
actually send out MIDI note and CC data unless otherwise noted.
IMPORTANT: Be careful not to touch Xponent's controls when the unit is powering on. Xponent automatically calibrates itself
when powering up and touching any of its controls during startup may cause the controller to work in unexpected ways. The
Progress Meters on each deck indicate the status of the calibration; once all of the Progress Meter LEDs are illuminated, the
remaining buttons on the unit will become lit and Xponent is ready to use.
Torq Xponent User Guide
Controls and Connectors