Dual-Filter; Distortion; Saturation Mode; Sample Rate Mode - M-Audio Torq Xponent User Manual

DUAL-FILTER:

X-axis: Controls the filter's cutoff frequency (parameter knob). When your finger is at the left of the pad, the parameter knob
will be fully counter-clockwise. In this position, the effect acts as a low-pass filter and removes most of the high-frequency
sounds playing from the associated deck. The cutoff frequency increases as your finger slides to the right of the pad. As
your finger passes the center of the pad, the filter seamlessly shifts from low-pass filter into a high-pass filter. This means that
when your finger reaches the rightmost edge of the Trackpad, most of the low-frequency sounds are filtered out.
Y-axis: Controls the resonance of the Dual-Filter, which is a hidden parameter. When your finger is at the bottom of the pad,
the resonance will be minimal (the on-screen knob will be fully counter-clockwise). As your finger slides up the Trackpad, filter
resonance increases.

DISTORTION:

Saturation Mode

X-axis: Controls the effect's Color, which is a hidden parameter. The effect knob is fully counter-clockwise as your finger is
on the leftmost edge of the pad. The knob turns clockwise as your finger slides to the right.
Y-axis: Controls the Drive knob. The amount of drive increases as you move your finger to the top of the pad.

Sample Rate Mode

X-axis: Controls Bit Depth, which is a hidden parameter. Music will be heard with full bit depth (no effect) when your finger is
on the leftmost edge of the Trackpad. Bit depth is reduced to 4 bits as the finger is moved to the right.
Y-axis: Controls the Sample Rate knob. The Sample Rate will be full (no effect) when your finger is at the top of the pad. As
you drag your finger down the pad, the sample rate will be reduced.

STROBE:

X-axis: Controls the Strobe Rate knob. Sliding your finger to the right of the Trackpad will increase the frequency (speed) of
the Strobe effect.
Y-axis: Controls the Wet/Dry Mix knob. The amount of the Strobe effect you hear increases as your finger slides from the
bottom of the Trackpad to the top.

REVERSE:

Touching the Trackpad engages the Reverse effect while releasing the pad turns the effect off.
Moving your finger along the X or Y axis of the Trackpad does not change this effect in any way.

BRAKE:

Touching the Trackpad engages the Brake effect while releasing the pad turns the effect off.
Moving your finger along the X or Y axis of the Trackpad does not change this effect in any way.

REPEAT:

X-axis: Controls the Repeat Size knob. Sliding your finger toward the right will increase the repeat rate (make it shorter).
Y-axis: Controls the Wet/Dry Mix knob. Moving your finger toward the top of the pad will increase the amount of repeat
effect that you hear.
Torq Xponent User Guide
|
18