Speed Dial - Vertex Standard EVX-5400 Operating Manual

c u /d
odE p oWn
Press, (or press and hold), the assigned PF key to select a 2-Tone or 5-Tone en-
code code from the pre-programmed encode list.
c s
odE Et
You can change the desired digit of the 5-Tone encode code using this function:
r Press, (or press and hold), the assigned PF key.
r Select the desired digit using the [ P1 ] / [ P2 ] keys, then change the number us-
ing the [  ] / [  ] keys.
r Press the [ P4 ] key to store the new setting. The display indicates "- SET -"
briefly, then reverts to the normal channel indication.
You may cancel the new setting by pressing the [ P3 ] key. In this case, the dis-
play indicates "-CANCEL-" briefly.
Note: If the optional MH-75
5-Tone encoding code directly from the microphone's numeric ([ 0 ] - [ 9 ]) key. In
this case, you may set and cancel the setting by the microphone's [ C ] (for cancel)
and [ D ] (for set) key.
s d
pEEd Ial
Your Vertex Standard dealer may have pre-programmed Auto-Dial telephone num-
ber memories into your radio.
To dial a number:
r Press, (or press and hold), the assigned PF key.
r Press the [  ] / [  ] keys to select the Auto-Dial memory number which is pre-
programmed by your Vertex Standard dealer, then press the PTT switch. The
DTMF tones sent during the dialing sequence will be heard in the speaker.
Note: If the optional MH-75
the Auto-Dial memory number by the microphone's numeric ([ 0 ] - [ 9 ]) key.
dtmF c s
odE
( This function requires the Optional MH-75
r Press, (or press and hold), the assigned PF key to start entering the DTMF di-
aling sequence.
r Enter the DTMF digit from the microphone's numeric ([ 0 ] - [ 9 ]) key.
r After entering all DTMF digits, press the PTT switch to transmit the DTMF
code.
EVX-5400 O
pErating
a
dvancEd
16-Keypad Microphone is used, you may enter the
A8J
16-Keypad Microphone is used, you may select
A8J
Et
M
anual
o
pEratIon
16-Keypad Microphone )
A8J
21