GE AJCH10DCB Datasheet page 2

GE Appliances
AJCH10DCB – GE ENERGY STAR
®
Dimensions (in inches)
Make frame if desired or caulk
Make frame if desired or caulk
between case and siding
between case and siding
15-3/4
26-1/8
26-1/8
Frame Construction
Frame Construction
Lintel
15-3/4
26-1/8
26-1/8
Brick Block and Brick
Brick Block and Brick
Frame Construction
Frame Construction
Specification Revised 2/06
390231
Brick Block and Brick
230/208 Volt Built-In Room Air Conditioner
®
Frame Construction
Lintel
OUTSIDE
15-3/4
Caulking
Drip Rail
Flexible Mounting Position
Lintel
15-3/4
Fill open cells
Fill open cells
with mortar
with mortar
or insulation
or insulation
Plaster Line
Plaster Line
Trim Molding
Lintel
15-3/4
26-1/8
Fill open cells
with mortar
or insulation
Plaster Line
Trim Molding
(if desired)
INSIDE
16-7/8
Installation Information: A finished opening of 26-1/8" x 15-3/4" clear
of intrusions is required. Keep clearance of 4" from side walls. Brick
veneer or frame walls should have wood studding surrounding case to
provide firm anchoring with screws. Case can be fastened directly to
brick or block walls with screws sunk in lead expansion shields.
Note: Units should be caulked on all four sides of case to the building
exterior to assure building integrity.
Two Wall Cases for Tenant Option Installation
When the air conditioner is offered as a tenant option, these wall
cases provide protection against outside elements.
RAB47 – includes wall case, exterior grille and steel closure panels.
RAB48 – includes wall case, exterior grille, steel closure panel and
two layers of insulation.
Standard Wall Case RAB46
Solid-sided wall case fabricated of galvanized steel with baked enamel
finish. Welded areas are coated with a sealing compound to help resist
rust and corrosion. Polymer gasket surrounds opening to assure tight
weather seal. Aluminum grille (RAG13) is included. Panels on interior and
between case and grille provide weather protection prior to installation
of chassis.provide firm anchoring with screws. Case can be fastened
directly to brick or block walls with screws sunk in lead expansion shields.
As an ENERGY STAR
®
partner, GE has determined
that this product meets the
ENERGY STAR guidelines
for energy efficiency.
For answers to your Monogram,
GE appliance questions, visit our website at
®
Listed by
Underwriters
GEAppliances.com or call
R Laboratories
GE Answer Center
Total capacity and E.E.R.
ratings are calculated
based on the Association
of Home Appliance
R
Manufacturers' standards.
GE Profile or
® ™
service, 800.626.2000.
®