Installation And Operating Instructions; Checks Before Installation - Hoshizaki KM-61BAH Instruction Manual

II. Installation and Operating Instructions
• Install in accordance with all applicable national, state, and local codes and
regulations.
• CHOKING HAZARD: Ensure all components, fasteners, and thumbscrews are
securely in place after installation. Make sure that none have fallen into the storage
bin.
A. Checks Before Installation
• Remove all shipping cartons, tape, and packing material. If any are left in the
icemaker, it will not work properly.
• Remove the shipping tapes holding the door and separator. See Fig. 1.
• Visually inspect the exterior of the shipping container and immediately report any
damage to the carrier. Upon opening the container, any concealed damage should also
be immediately reported to the carrier.
• Remove the panels to prevent damage when installing the icemaker. (See "B. How to
Remove Panels.")
• Remove the package containing the accessories.
• Remove the protective plastic fi lm from the panels. If the icemaker is exposed to the sun
or to heat, remove the fi lm after the icemaker cools.
• Check that refrigerant lines do not rub or touch lines or other surfaces, and that the fan
blade turns freely.
• Check that the compressor is snug on all mounting pads.
• See the nameplate on the upper part of the left side panel, and check that your voltage
supplied corresponds with the voltage specifi ed on the nameplate.
WARNING
NOTICE
10