Image 760 Treadmill User Manual page 8

5. The box inside of the Pulse Bar (71) fits into a cavity in
the pulse bar bottom; orient the pulse bar bottom so the
box is inside of the cavity. Attach the pulse bar bottom
with eight 3/4" Screws (108). Tighten the Screws indi-
cated by the arrows first, and tighten the center
Screws last. Be careful not to overtighten the Screws
or to pinch any wires.
Insert the Wire Harness (74) and the pulse wire through
the holes in the Top Endcaps (75). Press the Top
Endcaps into the Uprights (29, 30), with the holes at the
top as shown.
6. Remove the two Latch Screws (79) from the Left Upright
(29). Attach the Latch Housing (82) to the Left Upright
with the two Latch Screws. Make sure that the large hole
in the Latch Housing is on the side shown
Remove the knob from the pin. Make sure that the collar
and the spring are on the pin. (Note: If there are two col-
lars, place one on each side of the spring.) Insert the pin
into the Latch Housing (82) and tighten the knob back
onto the pin.
7. See drawing 7c. With the help of a second person, hold
the Console Base (101) near the Uprights (29, 30). Look
under the Console Base and locate the wires on the
sides of the Console Base. Make sure that the wires are
not routed through the openings for the Trays (109,
111). Drawing 7a shows the correct route for the wires.
Drawing 7b shows an incorrect route.
Locate the Wire Harness (74) and the pulse wire in the
Uprights (29, 30). Connect the Wire Harness and the
pulse wire to the connectors on the sides of the Console
Base (101). Make sure to connect the connectors
properly (see the inset drawings). IF THE CONNEC-
TORS ARE NOT CONNECTED PROPERLY, THE CON-
SOLE MAY BE DAMAGED WHEN THE POWER IS
TURNED ON. The connectors should slide together
easily and snap into place. If the connectors do not
slide together easily and snap into place, turn a connec-
tor and try to insert it again. Insert the excess Wire
Harness and pulse wire up into the Console Base.
5
74
75
108
30
6
Knob
82
79
Large
Hole
7a
Correct
7c
74
30
8
Pulse Wire
Box
71
75
108
108
Pulse Bar
Bottom
29
Spring
Pin
Collar
7b
Incorrect
111
109
101
29
Pulse
Wire
74
29