Image 760 Treadmill User Manual page 7

2. Insert one of the Extension Legs (92) into the Upright
Base (97). Make sure that the decal is in the indicated
location.
Insert the other Extension Leg (92) in the same way.
With the help of a second person, carefully tip the tread-
mill so the Upright Base (97) is flat on the floor.
3. With the help of a second person, carefully tip the Left
and Right Uprights (29, 30) down as shown. (Note: It
may be helpful to place your foot on one of the
Extension Legs [92] as you tip the Uprights.) Make sure
that the Extension Legs remain in the Uprights.
Attach the two Base Pads (99) to the Upright Base (97)
in the locations shown with two 1" Tek Screws (80).
Attach each Extension Leg (92) with two Extension Leg
Bolts (96) and two 1/4" Washers (39) as shown. Thread
the two Leveling Feet (95) into the Upright Base (97); do
not thread the Leveling Feet fully into the Upright
Base.
With the help of a second person, raise the Uprights (29,
30) to the vertical position. Remove the packing materi-
als from the brackets on the Uprights.
4. Hold the Pulse Bar (71) in the position shown. Locate the
pulse wire on the Pulse Bar. Insert the pulse wire into the
side of the Left Upright (29) and out of the top as shown.
Next, locate the ground wire on the Pulse Bar. Insert the
ground wire through the indicated slot in the bracket on
the Right Upright (30) (see the left inset drawing). Attach
the Pulse Bar to the brackets on the Uprights (29, 30)
with two 3/4" Screws (108). Make sure that the Screws
are in the holes shown in the inset drawings. Note: Press
the ends of the Pulse Bar onto the brackets as you
tighten the Screws. Make sure no wires are pinched.
Insert the Silver Ground Screw (103) into the ring on the
ground wire and tighten the Ground Screw into the indi-
cated hole in the bracket. Make sure that the ring on
the ground wire is turned as shown and that the
ground wire is parallel to the bracket. Insert the ex-
cess wire back into the slot.
2
Decal
92
3
99
30
92
39
4
Slot
108
103
103
108
30
7
97
92
29
80
39
92
61
96
95
96
108
71
Ground Wire
108
99
80
61
95
96
Pulse
Wire
29