Healthrider H95e Elliptical Manual page 8

4. Apply a generous amount of the included
grease to the Upright Axle (48) and to two Wave
Washers (118).
Tip: Avoid damaging the Wire Harness (60).
Insert the Upright Axle (48) through the Upright
(5) and center it. Slide a Wave Washer (118)
onto each side of the Upright Axle.
Next, identify the Right and Left Upper Body
Legs (6, 7), which are marked with “"Right”" and
“"Left”" stickers, and orient them as shown.
Slide the Right and Left Upper Body Legs
(6, 7) onto the right and left sides of the Upright
Axle (48).
Tighten an M8 x 16mm Screw (102) and an
M8 Washer (95) into each end of the Upright
Axle (48).
5. Identify the Right Pedal (14), the Right Gel
Cushion (55), and the Right Pedal Arm (12),
which are marked with “"Right”" stickers, and ori-
ent them as shown.
Set the Right Gel Cushion (55) on the Right
Pedal Arm (12). Then, set the Right Pedal (14)
on the Right Gel Cushion.
Attach the Right Pedal (14) to the Right Pedal
Arm (12) with two M6 x 50mm Screws (62), two
M6 x 12mm Screws (111), and four M6
Washers (112).
Attach the Left Pedal (not shown) and the
Left Gel Cushion (not shown) to the Left
Pedal Arm (not shown) in the same way.
4
60
95
118
102
7
5
5
14
55
12
112
111
8
Avoid damaging the
Wire Harness (60)
Grease
48
95
118
102
6
112
111
62