Healthrider H95e Elliptical Manual page 10

8. Identify the Right Link Arm (43), which is marked
with an “"R”" sticker. Orient the Right Link Arm as
shown.
Apply grease to the axle on the Right Pedal Arm
(12). Slide the Right Link Arm (43) onto the axle.
Attach the Right Link Arm (43) with an M8 x
16mm Screw (102), a Small Axle Cover (56),
and an M8 Washer (95).
Next, apply grease to a Link Arm Axle (114).
Insert the Link Arm Axle into the Right Upper
Body Leg (6) and the Right Link Arm (43) from
the side shown.
Insert a hex key into the M8 x 16mm Screw
(102) in the Link Arm Axle (114). Using a sec-
ond hex key, tighten another M8 x 16mm Screw
(102), a Small Axle Cover (56), and an M8
Washer (95) into the other end of the Link Arm
Axle.
Repeat this step on the other side of the
elliptical.
9. Identify the Right Upper Body Arm (8), which
is marked with a “"Right”" sticker, and orient it as
shown.
Have a second person hold the Right Upper
Body Arm (8) near the Right Upper Body Leg (6).
Locate the wire tie in the right side of the Upright
(5). Tie the wire tie to the Right Grip Wire (45).
Pull the upper end of the wire tie until the Right
Grip Wire is routed through the Upright. Then,
untie and discard the wire tie.
Tip: To prevent the Right Grip Wire (45) from
falling into the Upright (5), secure the Right
Grip Wire with the wire tie.
Tip: Avoid pinching the Right Grip Wire (45).
Attach the Right Upper Body Arm (8) to the
Right Upper Body Leg (6) with three M8 x 16mm
Screws (102).
Attach the Left Upper Body Arm (9) to the
Left Upper Body Leg (7) in the same way.
8
102
Grease
12
Wide
95
Tube
9
9
7
Wire Tie
10
Grease
6
114
Narrow
Tube
95
43
56
56
102
Avoid pinching the
Right Grip Wire (45)
5
6
8
45
102
102
102