Epic Fitness E 760 User Manual page 7

5. Hold a Ramp Wheel (50) inside of the bracket on one
of the Chrome Tubes (45). Hold the Chrome Tube and
the Ramp Wheel inside of the bracket on the Left
Pedal Leg (46). Slide a Wheel Cover (51) onto the
long part of a Bolt Set (101), and insert the Bolt Set
into the Left Pedal Leg, the Chrome Tube, and the
Ramp Wheel.
Slide a Wheel Cover (51) onto the short part of the
Bolt Set (101), and tighten the short part of the Bolt
Set into the long part.
Attach the other Chrome Tube (not shown) and the
other Ramp Wheel (not shown) to the right side of
the elliptical exerciser in the same way.
6. Identify the Left Pedal (48), which is marked with an
"L." Attach the Left Pedal to the Left Pedal Leg (46)
with two M8 x 52mm Button Screws (100), two M8
Split Washers (122), and two M8 Washers (132).
Attach the Right Pedal (not shown) to the Right
Pedal Leg (not shown) in the same way.
7. Have another person hold the Upright (2) in the posi-
tion shown. Make sure that the Upright is turned so
the three holes are aligned with the holes in the
Frame (1).
Connect the Upper Wire Harness (18) to the Lower
Wire Harness (53). Carefully pull the upper end of
the Upper Wire Harness to remove the slack from
the Wire Harnesses. Next, slide the Upright (2) onto
the Frame (1). Be careful to avoid pinching the Wire
Harnesses. Attach the Upright with three M10 x 25mm
Button Screws (123) and three M10 Split Washers
(118).
5
45
50
101
51
6
122
7
2
118
123
7
101
46
51
48
46
132
132
122
100
118
123
118
18
53
1