Epic Fitness E 760 User Manual page 6

2. While another person lifts the rear of the Frame (1),
attach the Rear Stabilizer (30) to the Frame with two
M10 x 105mm Button Screws (89).
3. Identify the Ramp Axle (39), which is the longest axle.
Next, identify the Ramp Axle Covers (41), which are
smaller than the Wheel Covers (not shown). Slide a
Ramp Axle Cover onto an M6 x 16mm Button Screw
(103) as shown, and tighten the Button Screw into one
end of the Ramp Axle. Next, apply a small amount of
the included grease to the Ramp Axle.
Have a second person hold the two Ramp Spacers
(42) against the indicated tubes on the Frame (1).
Align the tubes on the Ramp (33) with the Ramp
Spacers; make sure that the Ramp is turned as
shown. Insert the open end of the Ramp Axle (39) into
the Ramp, the Ramp Spacers, and the Frame. If nec-
essary, tap the Ramp Axle with a rubber mallet to
insert it.
Slide the other Ramp Axle Cover (41) onto an M6 x
16mm Button Screw (103), and tighten the Button
Screw into the open end of the Ramp Axle (39).
4. Slide an M6 Washer (102) onto an M6 x 16mm Button
Screw (103), and tighten the Button Screw into one
end of the Lift Axle (38). Next, apply a small amount of
grease to the Lift Axle.
Raise the Ramp (33). Insert the Lift Axle (38) through
the welded tube under one side of the Ramp, through
the motor screw, and then through the welded tube
under the other side of the Ramp. As you insert the
Incline Axle through the motor screw, make sure
that the motor screw does not turn.
Slide an M6 Washer (102) onto an M6 x 16mm Button
Screw (103), and tighten the Button Screw into the
open end of the Lift Axle (38).
2
3
33
Grease
39
103
41
4
33
Motor
Screw
103 38
102
Grease
6
30
1
89
Tubes
103
41
42
42
Tubes
1
103
102