Fluke 233 Application Manual page 50

Utilities
"I would GREATLY benefit from the Fluke 233 in the test-
ing and commissioning of distribution and transmission
substations. On the relay rack panels we install, we use
rear mounted link blocks for voltage and control. But we
need to also be at the front of the panels to measure the
voltage change, sense the timing of relays and contacts, so
the remote capabilities of the Fluke 233 would be a TRE-
MENDOUS asset for me to use and would speed my work up
dramatically, thus enhancing my productivity. It would also
reduce the need to have a second person come over to assist
me in testing, as I could connect my leads across the circuit in
the rear of the panel, then watch the display from the front of
the panel." R.D., Alabama
"I work in an electrical generation station. Setting gap voltage
on proximeters used to measure vibration on steam turbines
for electrical generation and boiler feed pumps requires a
long set of test leads or another person. Voltages are mea-
sured at a terminal cabinet approximately 25 to 30 feet from
where the adjustments are being made. Having a removable
display could make this a one man job. It definitely would
eliminate fumbling with long and tangled test leads."
P.E., Ohio
50