Table of Contents
Advertisement
Falcon 36 Operation Manual
Do not attempt to move the laminator across
anything other than a flat, level surface
without trained and qualified riggers. You
can be crushed or seriously injured.
The Falcon 36 Laminator is a large and
heavy piece of equipment. It is necessary to
employ LICENSED RIGGERS ONLY to
move the machine. The laminator is not
designed to be tipped up or sideways in any
way. Such action disturbs the exact
alignment of the rolling parts of the machine
and requires extensive realignment. GBC
Pro-Tech's warranty does not cover
malfunction of the equipment due to
mishandling and/or tipping.
GBC Pro-Tech bears no responsibility for
personal injury or damage due to moving the
laminator improperly.
6. Once the laminator is in place set the locking
mechanism on all four wheels to ON.
7. Remove any plastic strapping and packing paper
taped to the
s.
roll
Do not use a knife or other sharp instrument
during installation or while servicing the
laminator. You can cause irreparable
damage to the rolls.
8. Remove all packing materials to a safe distance
from the laminator.
A NOTE ABOUT RECYCLING
The crate components can be reused for shipping
the machine again, or can be disassembled and the
wood and screws recycled. The shrink wrap is not
recyclable, however, so it must be discarded.
GBC Pro-Tech 1997 October
WARNING
CAUTION
NOTE
A word about international shipments: As these are
heavy pieces of equipment, GBC Pro-Tech takes
every precaution to ensure that our laminators are
properly crated to the highest standards.
Before machines leave our loading dock, they are
pre-treated with a VCI protective film to provide
total corrosion protection. This protective film is
wrapped around the machine and completely sealed.
In addition, moisture absorbing silicone desiccite
packs are packed inside the crate and machine
cabinets.
Prior to start up of the machine, you must remove
the desiccite packs from each cabinet and discard.
DO NOT operate the machine with the desiccite
packs inside the cabinets.
Once the Falcon 36 Laminator has been unpacked
and moved into final position check each of the
following items.
Tools required:
1
/
" hex wrench
8
Adjustable wrench
Setup Procedure
1. Inspect the laminator for any obvious shipping
damage.
2. Remove the drive and control side cabinet
1
covers with the
/
" hex wrench by removing the
8
six screws holding each cover in place.
3. Inspect all the bolts and tighten any that were
loosened during shipping.
4. Check the upper main
handwheel to raise and lower the
move smoothly.
5. Set the nip. (See Section 4: Maintenance and
Troubleshooting for the procedure.)
6. Verify that both thermocouples make contact
with the
s. (See Section 4: Maintenance and
roll
Troubleshooting for the procedure.)
Installation
assembly by using the
roll
. It should
roll
2-7
Advertisement
Table of Contents
