Fisher & Paykel DD36SDFTX2 Installation Instructions Manual page 6

INTEGRATED MODELS ONLY - CUSTOM FRONT PANEL CALCULATIONS
5
FRONT PANEL SPECIFICATIONS
5⁄8 - 13⁄16" (16-20 mm) panel thickness
Maximum weight of panel: 20 lb (9 kg)
Adequately sealed to withstand moisture (122
Because of it being a hot and wet environment generally, the back and
sides of the panel should be completely sealed with a waterproof vapor
barrier (ie polyurethane) to prevent damage to the panel.
The back of the panel (including any integrated handle) should be
completely flush so that the seal between the panel and the rubber trim
is maintained.
The following calculations assume the top of the panel is aligned
with the top of the adjacent cabinetry:
WIDTH OF THE PANEL
Measure A (the width between adjacent door/drawer fronts)
and write it in the fi rst box below, then complete the equation.
clearance to
adjacent cabinet
front
A
(min. 1⁄16" (2 mm))
- x
2
HEIGHT OF THE PANEL
Measure B and write it in the fi rst box below, then complete
the equation.
ventilation gap
(min. 1⁄16" (2 mm))
B
-
Note: when the top of the dishwasher has to be lower than the
adjacent cabinetry, the panel can be increased in height.
O O
F/50 C @ 80% RH).
WIDTH OF PANEL
(min. 33 11⁄16" (855 mm))
=
HEIGHT OF PANEL
=
min. 1⁄16"(2mm)
WIDTH OF PANEL
HEIGHT
B
OF PANEL
min. 1⁄16" (2mm) ventilation gap with
external venting kit installed
min. 1⁄16"(2mm)
A
min. 1⁄16"(2mm)
min. 1⁄16"(2mm)
min. 1⁄16" (2mm) ventilation
gap with external venting
kit installed
6