Fisher & Paykel DD36SDFTX2 Installation Instructions Manual page 13

PULL THROUGH HOSES & MOVE INTO THE CAVITY
11a
vent either
through
same cabinet
or adjacent
cabinet as per
step 7b or 7c
Important!
Ensure correct chassis position. In order
for product to function, cabinetry must
not block the front panel from closing
hard against the chassis.
INTEGRATED ONLY - SECURE THE EXTERNAL VENT
13a
1
After routing the vent hose
through and out the hole
cutout, attach and secure the
vent by tightening the four
screws provided.
Vent Hose
(Integrated
models only)
As you push product in, pull through hoses and
cord, ensuring they don't get kinked or twisted.
Important!
If product cannot be pushed in far enough, pull
out again and rearrange hoses and cord. Do not
use excessive force, as doing so may squash the
hoses and lead to incorrect operation.
2
SECURE THE DRAWER
12a
Open the
drawer halfway.
Using a flat-bladed
screwdriver, prise
the gray
rubber plug out
of the trim moulding.
2
Using a small Philips
screwdriver,
screw through the trim
moulding, securing the
side mounting bracket
to the cabinetry.
Do not damage the
rubber trimseal.
1
Replace the gray
rubber plug back into
the trim moulding
and ensure the trim
seal is facing forward.
3
Repeat for all
four brackets.
13