Fisher & Paykel DD36SDFTX2 Installation Instructions Manual page 17

17
ADJUST PANEL HEIGHT TO ALIGN THE CABINETRY GAPS
19
+ or - 1⁄16" (2 mm)
Insert an appropriately sized Philips screwdriver into the hole
above the door pin and rotate the panel up or down to align the
gaps in your cabinetry.
Repeat on the other side if necessary.
The panel has a maximum travel of 1⁄16" (2 mm) up or down.
Important!
Integrated models: Ensure that you maintain a minimum of 1⁄16" (2 mm)
ventilation gap below the panel.
Designer models: Ensure you maintain a minimum of 5⁄16" (8mm)
ventilation gap below the panel.