Fisher & Paykel DD36SDFTX2 Installation Instructions Manual page 15

REMOVE THE DRAWER
11b
Product may
1
move. Mark
chassis position
on cavity
2
Press the release tabs
in on either side and
push back to release
3
drawer from runners
REFIT THE DRAWER ONTO THE RUNNERS
13b
Ensure the drawer is
now rotated
clockwise back.
5
1
Ensure the release tabs on
both sides are reset fully.
4
To prevent
kinked hoses,
we recommend
rotating the drawer
anti-clockwise and
resting it on its side
after removal.
Push drawer runners back in.
4
Before refitting the drawer,
ensure the hoses are not
twisted and the latches at
the rear of each drawer
runner are facing forward.
2
SECURE THE DRAWER TO THE CABINETRY
12b
The product has three pairs
of fixing points:
2
(Refer to PARTS SUPPLIED
for relevant parts)
Ensure the sound insulation
a pair of fixing holes either
side on the bottom
(use 1½ " (38 mm) fixing
screws & washers)
5
5
INTEGRATED ONLY - SECURE THE EXTERNAL VENT
14b
3
is repositioned correctly.
1
After routing the vent hose
through and out the hole
cutout, attach and secure the
vent by tightening the four
screws provided.
15
1
2
two pairs of formed
2
brackets on either side
of the chassis
(use 5⁄8" (16 mm) screws)
2