Table of Contents
Advertisement
To configure Device Events:
1. Go to System > Event Manager > Device Event Config. The Event
Configuration screen displays.
2. Select a Device Group or a Device Name.
3. Select the Type of event. The different events are:
TRAP
Up -> Down
Down -> Up
Cold Start
Warm Start
Link Down
Link Up
Device
Authentication Fail
EGP Fail
Figure 80:
Event Configuration screen
INDICATION
The link between the device and the workstation
(D-View) is disconnected.
The link between device and the workstation is
connected.
Device sends Cold Start trap message when the
device is powered off/on.
Device sends Warm Start trap message when
the device has been rebooted.
Device sends Link Down trap message when the
status of an attached communication interface
has changed from up to down.
Device sends Link Up trap message when the
status of an attached communication interface
has changed from down to up.
Device sends Authentication Fail trap when the
agent received a request from an unauthorized
manager.
In routers running the Exterior Gateway
Protocol (EGP), an EGP Neighbor has changed
to a down state.
Advertisement
Table of Contents
