Troubleshooting - Audio Pro RXD200 Owner's Manual

trOuBleshOOtinG

nO cOnnectiOn Between units
when wireless connection is established on same channel, led
on both transmitter and receiver(s) will go blue. if no connection,
led goes red. try this to ammend problem:
- set same channel (1, 2 , 3) is set on both tXd200 and rXd200.
- rXd200 receiver is out of range from tXd200 transmitter.
try placing the units in closer proxemity.
wireless cOnnectiOn, But nO sOund
- make sure to choose correct source on receiving device.
- check your audio source output is correct on transmitting device.
- make sure both transmitter and receiver has power. check all
connections and cables.
- computer. make sure you have chosen correct sound output.
see "mac & pc setup".
wireless interruptiOns
interruptions when playing music is usually not caused by the
wireless transmission in the audio pro wireless system. external
causes can influence the transmission quality. Below are a few
tips for improving transmission quality:
1. position all radio/wlan transmitters and receivers away from
each other. test out various locations for each device.
2. switch off the automatic search function in wlan devices.
wlan devices permanently scan for available frequencies, thus
constantly sending signals that could disrupt other radio systems.
3. avoid walls (if possible). audio pro technology wireless signals
can, of course, transmit through walls. however, walls may consist
of very different materials (plaster, wood, steel, concrete). walls
can contain complex cable installations for electrics, phones,
tvs, and radios, as well as water pipes and air shafts. these can
divert wireless signals.
4. do not operate any powerful electrical devices near the
transmitter. some electrical devices generate strong electro-
magnetic fields that could disrupt wireless systems.
If you experience problems not resolved by troubleshooting,
contact your local dealer/distributor any time for assistance.
Or contact the Audio Pro helpline at support@audiopro.se.