Audio Pro RXD200 Owner's Manual page 12

paired & unpaired mOde
By pairing, you lock your audio pro network from other peoples
audio pro wireless networks. in unpaired mode, the tXd200 and
rXd200 will work with all audio pro wireless products.
hOw tO pair tXd200 with rXd200
Set units to same House Code: 1, 2, or 3.
1. press pair button on tXd200 for 2 seconds, led
flashes Green. it will now search for rXd200 units to
pair with.
2. press pair button on rXd200 for 2 seconds, led
flashes Green.
3. when the units are paired, led goes to steady
Green.
Note:
• TXD200 will stay in pairing search mode for 60 seconds, if no
unit to pair with is found, TXD200 goes back to unpaired mode.
• TXD/RXD200 units who are paired, but looses connection
(power, out of range, change of house code), will show both
Green and Red LED.
• TXD200 can be paired to more RXD200 units. Repeat above
pairing to pair more RXD200 units.
• TXD/RXD-200 can be paired on 1 House Code and be
unpaired on other channel. pairing is only valid on the chosen
house code.
unpair units
1. disconnect tXd200 from power. 2. while pressing the pairing
button, reconnect the unit to power, 3. and hold pairing button for
6 seconds. the unit will now be unpaired.
led will flash red/Blue as it tries to search for unpaired rXd-200,
and then go to either red or Blue depending on if wireless con-
nection with rXd200 unit(s)is established.
Note: When you unpair the dongles it will be valid for all 3
House Codes. It's not possible to unpair a specific house code.