Battery Replacement - Viper 9211VL Owner's Manual

Battery Replacement

1.
sert into slot located on the side of the unit
as shown and carefully pry the front of the
unit up, working your way around the edge
until the front is completely separated from the
housing.
Note:
tact located inside the unit as shown does not
fall out during the replacement process.
2.
batteries from clip and replace.
Note:
correct when replacing. Batteries are
stacked in series and polarity is indicated.
3.
© 2012 Directed. All rights reserved.
Elastomer
contact
Using a small slotted screwdriver, in-
Front
Make sure that the small elastomer con-
Front
Turn the circuit board over, remove
Elastomer
contact
Verify that the battery polarity is
Reposition all parts and snap together.
Front
Elastomer
contact
Elastomer
contact
Elastomer
contact
Front
Circuit Board
Elastomer
contact
+ + Circuit Board
+
+
Front
Elastomer
contact
+ +
9