Advertisement
The Tom Dickson Extreme Blender Overview
(Refer to Figures 1a, 1b, and 2)
3.1 BLENDER MOTOR
• Blender Base Housing: Houses the power unit in a stainless steel casing.
Never remove the blender base cover. Removal of the cover will void the
warranty.
• Touch Pad: Consists of four pre-programmed buttons that contain settings
for selective blender control, a Pulse button, a Start/Stop button, a Cycle
Menu button, and two Speed control buttons.
• LCD Information Center: Indicates the status of unit as well as overload or
over-temperature conditions.
• Power Unit: This unit is located within the blender motor and contains the
machinery that runs the blender.
• Power Switch: Located on the front panel underneath the LCD display.
3.2 BLENDER JAR ASSEMBLY
The blender jar assembly consists of the blender jar, blade assembly, and lid.
• Jar: Made from BPA-free copolyester material to provide maximum efficien-
cy and clear visibility of blender performance.
• Blade Assembly: Made from stainless steel and designed to provide fast,
consistent blending.
3.3 POWER SPECIFICATIONS
The Tom Dickson Extreme Blender is made for 110/120 volts circuits only. It is
rated at 20 amps/2400 watts. It is necessary that this unit use a 20 amp recep-
tacle (see FIGURE 1b) and be protected by a 20 amp circuit breaker or fuse.
FIGURE 1b
20 AMP RECEPTACLE
4
SECTION 3
FIGURE 1a MOTOR BASE AND JAR FRONT VIEW
Lid
Jar
Blade Assembly
Motor Base
LCD Diplay
Power Switch
Advertisement
