Advertisement
Microsoft Windows for
Workgroups 3.11
Connecting to a Novell
NetWare 4.11 Server
13 Installing the Intel EtherExpress PRO 10+ ISA Ethernet Adapter
Microsoft Windows for Workgroups 3.11
13 Installing the Intel EtherExpress PRO 10+ ISA Ethernet
Adapter
Requirements
• HP Vectra with Windows NT3.51 Workstation.
• Intel EtherExpress PRO 10+ ISA Ethernet card and drivers disk.
• Microsoft Windows NT3.51 Workstation media.
• Novell NetWare 4.11 Server system that supports NetBEUI, TCP/IP,
NWLink IPX/SPX, and NWLink NetBIOS transfer protocols.
Device Configuration
Device Configuration
Interrupt
I/O Address
Procedure
1 With the HP Vectra turned off, install the Intel EtherExpress PRO 10+ ISA
Ethernet adapter card into an ISA slot.
2 Connect network cable media to the Intel EtherExpress PRO ISA
Ethernet adapter card.
3 Power on the machine and start the machine in MS-DOS mode.
4 Insert the Intel driver disk and execute "A:\SOFTSET2.EXE".
5 Select "Change Adapter Configuration" and verify the resource settings
listed above under the heading "Device Configuration".
6 If changes are required, save those changes and exit.
7 Remove the Intel Software driver diskette and restart the system.
8 After Windows loads, open the "Network" program group, and double-
click the "Network Setup".
Vectra Vli8
05
09
210
210
Vectra VEi7
Vectra VEi8
07
210
Advertisement
