Advertisement
9 Open the "Network Properties" window and agree to install "Windows NT
Networking".
10 With "Wired to the Network" checked, click on "Next".
11 Click on the option to "Select from list" then on "Have Disk".
12 Insert the Intel EtherExpress PRO/10+ ISA Ethernet driver disk into the
floppy drive.
13 Highlight the adapter labeled "Intel EtherExpress [TM] PRO/10+ ISA LAN
Adapter" and click on "OK".
14 With "Intel EtherExpress [TM] PRO/10+ ISA LAN Adapter" listed in the
"Network Adapters:" windows, click on "Next".
15 Accept the applicable network protocols and click on "Next".
16 At the "Network Services:" prompt, accept default settings and click on
"Next".
17 Finish the network card installation by clicking on "Next".
18 Designate the path to your NT files and select "Continue".
19 If you intend on using DHCP, then click on "Yes" and skip the next step;
otherwise click on "No".
20 Enter the required information, "IP Address", "Subnet Mask", "Default
Gateway", "DNS" and "WINS" information and click on "OK".
21 At the "Show Bindings for:" window, accept default entries and click
"Next".
22 When "Windows NT is now ready to start the network..." click on "Next".
23 Specify your Computer Name, Workgroup or Domain and click on "Next".
24 After the message "Network has been installed on this computer" click on
"Finish".
25 To complete the installation, select "Yes" to reboot your computer.
8 Installing the Intel EtherExpress PRO 10+ ISA Ethernet Adapter
Connecting to a Novell NetWare 4.11 Server
Advertisement
