Gateway AD-520 User Manual page 63

Menu Setting
Audio Setup Audio Out
Downmix
Audio DRC
Ratings Setup Password
Description
Select the type of audio signal you are using. Options
include:
Analog - Select this when outputting an analog audio
■
signal using the Audio Out Left and Audio Out Right
jacks.
SPDIF/Stream - Select this when outputting the digital
■
audio signal as it was recorded using the AC-3 Toslink
jack.
SPDIF/PCM - Select this when converting DTS or
■
Dolby Digital bitstream to linear PCM (2 channel) of
48 kHz/16 bit and outputting it.
Select your preferred analog audio signal format.
Options include:
LT/RT - Select this when you have connected the
■
player's audio out jacks to an A/V amplifier or receiver
with built-in multi-channel surround decoder.
LO/RO - Select this when you have connected the
■
player's audio out jacks to a stereo amplifier, receiver,
or television to hear two-channel stereo sound.
Select whether to turn on or turn off dynamic range
compression, which makes faint sound easier to hear at
low volume levels. This function is only available while
playing a disc recorded with Dolby Digital. Options
include:
On - Turn on dynamic range compression.
■
Off - Turn off dynamic range compression.
■
Select to change the password for the parental lock. The
player's password was set to 3308 at the factory. After
you select Change, you will be asked for the old
password and a new password. Enter a four-digit
sequence using the remote control. Options include:
Change - Change the password
■
Note: If you forget the password you set, use 3308.
www.gateway.com
Using the Setup menu
57