Push.button.security - D-Link DHP-541 Manual

Section 2 - Installation
Push Button Security
Understanding PowerLine AV 500 Network Security
The PowerLine AV 500 4-Port Gigabit Switch Starter Kit must use an identical encryption key for the network. The default encryption key for each
PowerLine AV 500 device is HomePlugAV. All PowerLine AV 500 4-Port Gigabit Switch Starter Kits with a default encryption key can communicate
with each other.
It is recommended to create a private encryption key for network security purpose. The private encryption key allows you to protect your network
from unauthorized access via the PowerLine network. To create a private encryption key instead of the default encryption key, please follow below
steps:
Step.1.-.PowerLine.AV.500.4-Port.Gigabit.Switch.(DHP-540)
Press the Simple Connect button located on the top of the switch for no more than two seconds. The Power LED
will start blinking after you release the button. The switch will create a private, randomly generated encryption
key that the PowerLine AV 500 devices in your network will use.
Step.2.-.PowerLine.AV.500.Network.Adapter.(DHP-502AV)
DHP-540
Within two minutes of pushing the Simple Connect button of the switch, press the Security Button on the
adapter for no more than two seconds. The Power LED will start blinking after you release the button.
Note: Both Security buttons must be pressed within two minutes.
Step.3.-.PowerLine.Network
After the above network security setup steps, your PowerLine network will be securely configured with the
same network encryption key. The PowerLine AV 500 switch and adapter will memorize the security settings
DHP-502AV
even if they are unplugged.
Note: To change the private encryption key, please reset the adapter back to its default value by pressing the Reset
button for two seconds and then follow the security setup procedure above.
D-Link DHP-541 User Manual 11