Push Button Security - D-Link DHP-302 User Manual

Section  - Installation
Plug in all the adapters to be configured.
Note: It is strongly recommended to designate the local adapter as the one that is directly connected to your router. This local adapter will act
as the security key master in the network. Each additional adapter you proceed to add afterwards will be referred to as a 'remote' adapter.
Local adapter
Press and hold the push button down until the local adapter AP LED begins to flash. Wait until the AP LED stops flashing (up to 30
seconds). At this point the local adapter is now assigned as the master adapter in your network.
Press and hold the button
To proceed securing the remote adapters follow the 3-step process below
D-Link DHP-30 User Manual

Push Button Security

Local Adapter Local Adapter