Setting Up The Unit: Charging/Turning The Unit On And Off - iHome iBT30 Instruction Manual

Setting Up the Unit: Charging
1. Connect the included AC adaptor to the DC jack
located on the back of the charging base and connect
the other end to a working wall outlet. Place unit on
charging base. For first time use, leave unit on
charging base until fully charged (about 10 hours).
You can operate the unit while it is charging. The
status indicator on the front of the unit will flash red
when the unit needs charging and glow steadily red
while it is charging. Once the unit is charged, the red
status light does not appear.
Turning the Unit ON and OFF
1. Slide the Power Off/On Switch located on the back of
the unit to the on position (right) to turn the unit ON.
The status indicator on the front of the unit will glow
blue.
2. To save power when operating on the internal battery,
press the Power Button located on top of the unit to
enter standby mode, which uses less power, but still
allows normal operation. The status indicator on the
front of the unit will turn off. Note that if no audio is
detected within 3 minutes when power is on, the unit
automatically reverts to standby mode.
3. Slide the Power Off/On Switch to the off position (left)
to turn the unit OFF.
Using the
charging base
3
iBT30
outlet
12V