Before Calling; For Service - LG LRE30955ST Owner's Manual & Cooking Manual

BEFORE CALLING FOR SERVICE
Before you call for service, review this list. It may save you time and expense. The list includes common occurrences that are not
the result of defective workmanship or materials in this appliance.
Possible cause / Solution
• Poor installation. Place oven rack in center of oven. Place a level on the oven rack.
Adjust leveling legs at base of range until the oven rack is level.
Be sure ffoor is level and is strong and stable enough to adequately support range.
If floor is sagging or sloping, contact a carpenter to correct the situation.
Kitchen cabinet alignment may make range appear unlevel. Be sure cabinets are square
and have sufficient room for range clearance.
• Cabinets not square or are built in too tightly. Contact builder or installer to make appliance
accessible.
• Carpet interferes with range. Provide sufficient space so range ean be lifted over carpet.
Elec'_oniccontrolhas detected file faultcondition.Touch ClXAR/OFF to dear file display mid stop beeping.
Reprogrmn oven. If fault recurs,record fault number. Touch CIXAR/OFF m_dcontact a Sendee agent.
F-1 OpenedSensor OvenThermistor remainsopen for over 1 rain,after cook starts Duringcook
F-2 ShortedSensor OvenThermistor is short for over l min after cook starts Duringcook
F-3 T/S Key Error When touch sensor key has some error for >= 60 seconds.
F-6 Oven hot Oventemperature is over650°Fcontinuouslyduring 2 minutes Duringcook
on cooking.
F-10 DoorLock Fail In case of Door Lock Failure MotorOperation
F-11 No heating If current oven temperaturedoes not exceed 150°Fand less Duringcook
equalthan start temperatureover 5 minutes on preheating,
where door is closed.
• Imwoper cookware being used.
- Use pans which are flat and match the diameter of the surface unit selected.
• In some areas, the power (voltage) may be low.
- Cover pan with a lid until desired heat is obtained.
•A fuse in your home may be bloml or the circuit breaker tripped.
- Replace the fuse or reset the circuit breaker.
• Cooktop controls improperly set.
- Cheek to see the correct control is set fur the surface unit you are using.
• This is normal. The unit is still on and hot.
• Food spillovers not cleaned befure next use.
- See Cleaning the glass cooktop section.
• Hot surface on a model with a light-colored cooktop.
- This is normal. The surface may appear discolored when it is hot. This is temporary and
will disappear as the glass cools.
• This is normal.
- The element will cycle on and offto maintain the heat setting.
-39-