Advertisement
Operation
:
Notes
Air conditioner setting will be changed after operation some minitues using wired controller.
Under the same condition(running mode setting temp. fan speed and wind direction
adjustment automaticly),everyday repeat operation for air conditioner's start/change,just need
press ON/OFF button.wired controller will display previous content.
REMARK
Avoid pressing ON/OFF switch frequently.
For protect unit.The third bit dip switch is ON,when outdoor ambient temp. is lower 10
than 50
,unit will not run in cooling mode;when outdoor ambient temp. is lower -10
than 0
,unit will can't run in heat mode.if the third dip switch is OFF,it has not limit.
when pressing temp. setting switch to change the temp.,the air conditioner may stop running.which is
because that the temp. controller is started,not unit fault.
during cooling(heating) mode,even if the room temp. lower(higher) than setting temp.,air conditioner
may be also run in this mode,which is normal.
When the wired controller is power on firstly, the screen will display full screen for two seconds. and
LED and clock zone will show 8888 - 888 - 88 - 8 flicker for 30 seconds. All the switches all invalid
at the time.
The fan speed is fixed, which can not be switched. Fixed is shown on the line controller.
11
or higher
or higher
Advertisement
