Table of Contents
Advertisement
T55D.book Page 24 Monday, August 31, 1998 5:46 PM
24
7.
If you are installing an arm or wall-mounting device, follow the directions
included with the device. If you are just changing your cables, continue
with Step 8.
8.
Connect the signal cable and the power cord, then refit the power cord
clamp in its original screwpost.
9.
Slide the stand cover back on the stand.
10. Put the hinge cover back on, making sure that the straight side is at the
top.
11. Insert the three tabs at the top of the cable cover into the slots in the
back of the monitor and push the cover into place.
To obtain the correct cables and/or to get further instructions on installing
them, call the IBM HELPCENTER at the above numbers or contact your
dealer, retailer, or other IBM authorized Servicer.
Advertisement
Table of Contents
