Samsung ML 1710 - B/W Laser Printer Service Manual page 70

7.1.9 Ghost (1)
• Description Ghost occurs at 75.5 mm intervals of the OPC drum in the whole printing.
Digital Printer
1. Bad contacts caused by contamination
Digital Printer
Digital Printer
Digital Printer
Digital Printer
Digital Printer
2. Bad contacts caused by contamination
3. The life of developer is expired.
4. Transfer roller lifetime(60.000 sheets) has
5. Abnormal low temperature(below 10°C).
7.1.10 Ghost (2)
Ghost occurs at 75.5 mm intervals of the OPC drum in the whole printing.
• Description
(When printing on card stock or transparencies using manual feeder)
Digital Printer
When printing on card stock thicker than nor-
Digital Printer
mal paper or transparencies such as OHP,
Digital Printer
higher transfer voltage is required.
Digital Printer
Digital Printer
Digital Printer
Samsung Electronics
Check and Cause
from toner particles between high voltage
terminal in the main body and the elec-
trode of the Developer.
from toner particles between high voltage
terminal in the main body and the one in
the HVPS board.
expired.
Check and Cause
T RO U B L E S H O OT I N G
Solution
1. Clean the terminals when contaminated by
toner particles.
2. Occur in the developer cartridge, replace
the developer and try to print out.
3. Replace the engine board if not solved by
the above directions 1-2.
4. If not solved by the direction 3, check the
transfer roller lifetime and replace it.
5. Wait about 1 hour after power on before
using printer.
Solution
Select 'Thick Mode' on paper type menu from
the software application and after using return-
ing to the original mode is recommended.
Service Manual
7-5