Installing Pharos Gps Hardware - Pharos Smart Navigator User Manual

8.2 Installing Pharos GPS Hardware

iGPS-SD
1.
Insert the iGPS-SD into
the Secure Digital Card
port of the Pocket PC.
Make sure you have
installed the iGPS-SD
driver from the driver
disc. This is a separate
process from installing
any other software.
2.
To install the driver,
connect your device to
the computer/laptop via
Microsoft Activesync and
run the Setup from the
Driver Disk. When
finished, perform a soft
reset on your device,
making sure the iGPS-
SD driver is plugged into
your device. This will
activate the driver and
allow you to use the
GPS receiver.
iGPS-SD
PDA
85