Gps Receiver Setup And Configuration; Configuring Gps In Smart Navigator - Pharos Smart Navigator User Manual

Table of Contents

8.0 GPS Receiver Setup and Configuration

Note:

For Pharos All-In-One devices, the GPS receiver does not need to

be setup or installed because it is already built into the device.

Note:

Com Port Selection only applies if using Windows Mobile-based

devices (does not apply to Pharos All-In-One devices)

The first time Smart Navigator starts, the Select Com Port screen can be

retrieved by pressing

Comm Port. The screen allows you to configure the communication port

that the GPS will be using. You can select the Com Port manually or

automatically.

.button à GPSà GPS Settingà Selecting

Selecting Auto will allow

Smart Navigator to configure

your GPS automatically. For

Bluetooth GPS users, this

should be sufficient.

For Serial, CF, and SDIO GPS

receivers, the Com port must

be set manually. To set the

Com port manually, please

refer to the User Manual of

your handheld device for the

appropriate Com Port #.

Select the COM# from the list,

and tap the Next button when

finished.

Table of Contents

Show Quick Links

Table of Contents