Kenmore TRIM AND RISER KIT Installation Instructions Manual page 3

Shims ,_ _ SideMin 3/4"PaneiCabinet
Install Side Trim flush
with cabinetry
_ 3/4" Mounting Screw (M)
Figure 9
Figure 10
(Shown from inside the rough opening;
backside of grill showing)
Using a carpenter's level, check that each side is vertical.
Shim as necessary (shims are not included). Next, secure
top and bottom of each side trim to cabinetry using two 3/4"
mounting screws (M). See Figure 11.
• Place a washer on the bolt and feed the bolt through the hole
in the top of the riser kit and into the threaded hole in the foot
of the unit. DO NOT TIGHTEN AT THIS TIME.
Repeat the above procedure for the three remaining
attachment points. See Figure 13.
Once all four bolts are secured to the four feet of the unit,
tighten the bolts using a 1/2" socket or open end wrench.
After installation, carefully tip the unit up with the help an
assistant.
\
\\
Figure 12
Level
Side
Figure 11
INSTALLING THE RISER KIT:
• First, place a protective covering on the floor to prevent
damaging either the refrigerator unit, freezer unit or the floor.
• Lay the unit on its side, making sure the side with the handle
is laying closest to the floor to prevent door from falling open.
• Remove the two plastic leg levelers on the bottom front side
of the units.
• Remove riser from its box. Locate plastic bag containing the
mounting hardware needed to install the riser kit to the unit.
The bag should contain four mounting bolts and four washers
for each riser.
• Position the riser on the bottom of the unit, making sure the
slanted end is toward the back of the unit.
Figure 13
3