Kenmore TRIM AND RISER KIT Installation Instructions Manual page 2

• Slide grill a ssembly intotopcollar t rim(A). T ape together to
prevent from sliding• See Figure 3 .
Front View
Figure 3
Attach brackets (K) to the angled end of each side trim (B
and C). Gently secure brackets to side trim by tightening set
screws (L) only until snug to avoid dimpling the extrusion
face. DO NOT OVERTIGHTEN. See Figure 4.
Protect Flooring
Figure 6
Making sure the frame is flush up against the front surface of
cabinetry, carefully run one mounting screw (M) through the
center hole d the top trim (A) and into the cabinetry. DO NOT
TIGHTEN AT THIS TIME.
NOTE: Some cabinet substrates may require pre-dritting holes
using a 1/8" diameter drill bit.
Level the top of the trim frame using a carpenter's level• See
Figure 7.
Figure 4
Join each side trim (B and C) to the top trim (A). Make sure
the ends of the Grill Assembly are captured in the channel of
each side trim, then tape in place• Gently secure brackets
(K) to top trim (A) by tightening set screws (L), only until snug
to avoid dimpling the trim face. DO NOT OVERTIGHTEN.
See Figure 5.
Figure 5
INSTALLING TRIM & GRILL ASSY. INTO CABINETRY:
" First, place protective covering where side trim will contact
the floor near rough opening. Then, stand up the grill and
frame assembly and center in rough opening. You may need
to use several pieces of tape at the top corners and top center
to temporarily hold the assembly in place. See Figure 6.
Figure 7
Shim as necessary (shims are not included)• See Figures 8
and 9 and 10. Next, secure both ends of top trim (A) to
cabinetry using two 3/4" mounting screw (M) through the holes
at each end. Make sure all three screws are snug across the
top.
.....
Back side
of Trim
Shims
Figure 8