Control Panel; Door - GE JDP47 Owner's Manual

Careand cleaning of the range.
Painted Surfaces
Painted surfaces include the doo_; top of
the control panel and the drawer front.
Cleml tbese with soap and water or a
vinegar and _ter solution.
Do not use commercial oven cleanm.-s,
cleaning powders, steel wool or harsh
abrasives on any painted surface.
Control Panel
Clean Lipsplatters widl a damp clodl.
% You may also use a glass cleaner.
/}}5 Remove heavier soil witb warm
soapy w-ater.
/}}5 Do not use abrasives of any kind.
The gasketis designedwith a gapat the
bottomto allow for proper air circulation.
Do not rub or clean the door gasket--
it has an extremelytow resistanceto
abrasion,
If you notice the gasketbecomingworn,
frayedor damagedinany wayor if it has
becomedisplacedon the door,you should
have it replaced.
Cleaning the Oven Door
Toclean theinsideof thedoor.
N Because the area inside tim gasket is
cleaned during tim self-dean cycle, you
do not need to clean tiffs by hand.
_ The area outside tim gasket and
the door liner can be cleaned witb a
soap-filled steel wool or plastic pad,
hot water and detergent. Rinse well
with a vinegar and vcater solution.
Toclean theoutsideofthe door:
_ Use soap and wcater m tboroughly
clean the rap, sides and front of the
oven door. Rinse well. You may also
use a glass cleaner to clean tbe glass
on tim outside oftbe door. Do not let
water drip into the vent openings.
_ If any stain on the door vent trim is
persistent, use a soft abrasive cleaner
and a sponge-scrubber for best results.
_ Spillage of"marinades, fruit juices,
tomato sauces and basting materials
containing acids may cause
discoloration and should be wiped
up immediately. When surface is cool,
clean and rinse.
_NDo not use oven cleane_.'s, cleaning
powders or harsh abrasives on tbe
outside of tile door.
Slot
Hingelock
Pull hinge locks down to unlock.
Removal position
Lift-Off Oven Door
Thedooris veryheav_. B e carefulwhen
removing and liftingthe door.
Donotlift thedoorbythehandle.
Toremovethe door:
[] Fully open tbe door.
[]
[]
[]
Pull the hinge locks down to,a-ard
the door frame, to tim unlocked
position. A tool, such as a small
flat-blade screwdriver, may be
required.
Firmly grasp both sides of the door
at the top.
Close door to tbe door removal
posmon, which is halfway between
the broil stop position and fully
closed.
[] Lift door up and out until tile hinge
arm is clear oftbe slot.
Toreplace the door:
[] Firmly grasp both sides of tile door
at the top.
] With die Bottom
earm
door at tile
same angle as
tim removal
position, seat the
indentation of
tim hinge arm
into tim bottom
edge of tim hinge
slot. The notch in the hinge arm
must be fhlly seated into the bottom
of"tim slot.
[] Fully open the door. If the door will
not fully open, tim indentation is
not seated correctly in the bottom
edge oftbe slot.
[] Push tim hinge locks Lipagainst the
front frame of tile oven cavity to the
locked position.
Hinge
arm
Push hinge locks up to lock.
22 []
Close tile oven door.