Replacing The Oven Door - GE JKP85 Installation Instructions Manual

Installation Instructions
Preparing for the bottom
Trim Installation
a. With oven installed, take the bottom trim
and center it on the bottom front edge of
the cabinet opening.
b. Using the trim as
a template mark
the center of
each slot (three
total) where
the mounting
holes will be
drilled.
c. Remove the trim.
Mounting Holes
d. Drill pilot holes into the center of each
template mark.
Installing the Bottom
Trim
a. Place the bottom trim centered over the
pre-drilled mounting holes. Tape the edges
of the trim down to maintain the alignment.
Side
Trim
Screw
Side
Lower
Trim
b. Using the three pan head trim screws
provided secure the bottom trim to the
bottom edge of the cabinet.
IMPORTANT: If this unit is ever removed
from the cabinet or the cavity is ever
pulled out for service, the trim must be
removed first or damage to the trim will
occur.
Replacing the Oven
Door
The oven door is heavy. You may need
help lifting the door high enough to
slide it into the hinges slots. Do not lift
the door by the handle.
Replacing the Oven Door _
Pick the Oven Door up by
placing one hand on each
side. The door is heavy so
you may need help. Do not
lift the door by the handle.
i i i
Place the notch of the
hinge arm into the
bottom edge of the
hinge slot.
I_ Open the oven door as
far as it will open.
Bottom Edge Hinge Arm
Of Slot, _
Hinge Notch
Push the hinge locks
up against the front
frame of the oven
cavity, to the locked
position.
Close the oven door.
Hinge in
Locked Position
Notch of
Hinge Securely
Fitted into Bottom
of Hinge Slot
9