GE JKP86 Installation Instructions Manual
27" built-in wall oven with microwave
Hide thumbs
Also See for JKP86:
- Owner's manual (45 pages) ,
- Installation instructions manual (13 pages) ,
- Technical service manual (51 pages)
Table of Contents
Advertisement
Quick Links
Installation
Instructions
27" Built-In Wall Oven
with Microwave
JKP86
If you have questions, call 1.800.GE.CARES or visit our website at:
www.GEAppliances.com
Before You Begin
Read these instructions
carefully and completely.
• IMPORTANT-save
these
instructions
for local inspector's
use.
• IMPORTANT-observe a,
governing
codes and ordinances.
• Note to Installer--Be
sure to leave these
instructions
with the consumer.
• Note to ConsumermKeep
these
instructions
for future reference,
• Proper installation
is the responsibility
of the installer
and product
failure due
to improper
installation
is NOT covered
under warranty.
• NOTE--This
appliance
must be properly
grounded.
• ATTENTION INSTALLER
All electric wall ovens must be hard wired
(direct wired) into an approved junction
box. A plug and receptacle
is NOT permitted
on these products.
Parts Included
Screws For Installation
Metal Bottom Trim
Tools Needed
1/8" Drill Bit and
Electric or Hand Drill
Phillips
Screwdriver
Materials Needed
__
@
Wireaunts
Strain Relief Clamp
Junction
for 1/2" conduit
Box
€ %-_'_-,,
36" of String
229c4053P507-3
31-10526-3
o6-o3JR
Advertisement
Table of Contents
Related Manuals for GE JKP86
Summary of Contents for GE JKP86
- Page 1 Installation 27" Built-In Wall Oven with Microwave Instructions JKP86 If you have questions, call 1.800.GE.CARES or visit our website at: www.GEAppliances.com Before You Begin • Proper installation is the responsibility of the installer and product failure due Read these instructions carefully and completely.
-
Page 2: Important Safety Instructions
Installation Instructions IMPORTANT SAFETY INSTRUCTIONS Electrical For Your Safety Requirements • Be sure your oven is installed properly a qualified installer or service technician. This appliance must be supplied with the • Be sure the oven is securely installed in a proper voltage and frequency, and connected cabinet that is firmly attached to the house... -
Page 3: Pre-Lnstallation Checklist
Installation Instructions Pre-lnstallation Checklist Remove packaging materials. Check Door removal is not a requirement installation of the product, but is an inside microwave, behind hinges and added convenience. To remove the door: under false bottom. Remove labels on the outside of the door, plastic on trims Open the oven door as far as it will go. - Page 4 Installation Instructions I_ Pre-lnstallation Checklist cont. Remove the bottom trim from the top lace the oven on a table or platform of the oven. It will be installed at the even with the cutout opening. (Platform must support 255 Ibs.) end of the installation process.
- Page 5 Installation Instructions Cutout for Built-In Oven with Microwave Cabinet Width Junction Box 27" Location Cabinet Recommended 27" Minimum Cutout Location Cutout Width from Floor 21 5/8" Allow 7/8" for 25" Min. overlap of oven 25 1/4" Max. over side edges 23 112"...
-
Page 6: Electrical Connections
Installation Instructions Electrical Connections Turn off the circuit breaker or remove ATTENTION INSTALLER fuses to the oven branch circuit. All electric wall ovens must be hard wired With the oven supported on a table or (direct wired) into an approved junction platform in front of the cabinet opening,... - Page 7 Installation Instructions IBI Electrical Connections cont New Construction and Three-Conductor Branch Four-Conductor Branch Circuit Connection Circuit Connection When connecting to a three-conductor branch circuit, if local codes permit: • When installing in new construction, a. Connect the bare oven ground conductor •...
-
Page 8: Securing The Oven In The Opening
Installation Instructions Securing the Oven in the Opening Sliding the Oven Into the Drilling the Pilot Holes and Opening Mounting the Oven a. Loop (do not tie) a 36" string around the conduit before the oven is slid into place. NOTE: Before drilling the pilot holes, This will keep the conduit from falling make sure the oven is pushed as far... - Page 9 Installation Instructions Preparing for the Bottom Installing the Bottom Trim Trim Installation a. Place the bottom metal trim centered over a. With oven installed, take the bottom trim the pre-drilled mounting holes. Tape the and center it on the bottom front edge of edges of the trim down to maintain the the cabinet opening.
- Page 10 Installation Instructions 151 Replacing the Oven Door _'-_ Open the oven door as far as it NOTE: The oven door is heavy. You will open. may need help lifting the door high enough to slide it into the hinge slots. _"_ Push the hinge locks up against the Do not lift the door by the handle.
-
Page 11: Pre-Test Checklist
Installation Instructions Pre-Test Checklist Check that the bottom trim is installed emove all protective film, if present, and any stickers. properly (see page 9). Check to be sure the mounting screws Check to be sure that all wiring is are installed and flush with the side trim secure and not pinched or in contact with moving parts. - Page 12 NOTES...