Pre-Test Check List; Operation - GE JKP85 Installation Instructions Manual

Installation Instructions
PRE-TEST CHECK LIST
Check that the bottom trim is installed
Remove all protective film if present,
and any stickers. _ properly (see page 9).
Chec to sure that all wi in0 is
secure and not pinched or in contact
with moving parts.
Check to be sure the mounting screws
are installed and flush with the side
trim, (see page 9).
_ Operation Checklist
[_ emove all items from the inside 11k61rl
of the oven.
I_ Checkthat conduit is securely
connected to the junction box.
Turn on the power to the oven.
(Refer to your Use and Care
Manual.) Verify that the bake and
broil units, and all cooking
functions operate properly.
Check that the circuit breaker is
not tripped or the house fuse is
blown.
See Use & Care manual for
troubleshooting list.
NOTE TO ELECTRICIAN:
The power leads supplied with this
appliance are UL recognized for
connections to larger gauge
household wiring. The insulation of
these leads is rated at temperatures
much higher than the temperature
rating of household wiring. The
current carrying capacity of a
conductor is governed by the wire
gauge and also the temperature rating
of the insulation around the wire.
NOTE: ALUMINUM WIRING
A. WARNING:
IMPROPER CONNECTION OF
ALUMINUM HOUSE WIRING TO
THE COPPER LEADS CAN
RESULT IN A SERIOUS PROBLEM.
B. Splice copper wires to aluminum
wiring using special connectors
designed and UL approved for
joining copper to aluminum and
follow the manufacturer's
recommended connector
procedure closely.
NOTE:Wire used, location and
enclosure of splices, etc., must
conform to good wiring practice
and local codes.
10