Maintenance And Troubleshooting - ProForm PFEX72411.1 User Manual

MAINTENANCE AND TROUBLESHOOTING

Inspect and properly tighten all parts of the exercise
bike regularly. Replace any worn parts immediately.
To clean the exercise bike, use a damp cloth and a
small amount of mild soap. IMPORTANT: To avoid
damage to the console, keep liquids away from
the console and keep the console out of direct
sunlight.
CONSOLE TROUBLESHOOTING
If the console display becomes dim, replace all the
batteries at the same time; most console problems are
the result of low batteries. To replace the batteries, see
assembly step 12 on page 10.
If the handgrip heart rate monitor does not function
properly, see step 5 on page 15.
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the
reed switch should be adjusted.
To adjust the reed
switch, you must
first remove the Top
Shield (9). Using a flat
screwdriver, release
the tabs near the rear
and front of the Top
Shield. Then, slide the
Top Shield upward.
Locate the Reed Switch (21). Turn the Pulley (13) until
a Pulley Magnet (16) is aligned with the Reed Switch.
Loosen, but do not remove, the indicated M4 x 15mm
Screw (64).
13
21
16
64
Slide the Reed Switch (21) slightly closer to or away
from the Pulley Magnet (16), and then retighten the M4
x 15mm Screw (64). Turn the Pulley (13) for a moment.
Repeat these actions until the console displays correct
feedback.
When the reed switch is correctly adjusted, reattach
the top shield.
HOW TO ADJUST THE DRIVE BELT
If you can feel the pedals slip while you are pedaling,
even when the resistance is adjusted to the highest
level, the drive belt may need to be adjusted. To adjust
the drive belt, you must remove the top shield, the right
pedal, and the right shield (see the instructions below).
See the drawing at the left. Using a flat screwdriver,
release the tabs near the rear and front of the Top
Shield (9). Then, slide the Top Shield upward.
Next, using an adjustable wrench, turn the right pedal
counterclockwise and remove it. Then, remove the
screws from the right and left shields, and gently
remove the right shield.
Loosen the M6 x 20mm Hex Screw (60). Then, tighten
9
the M10 x 50mm Hex Screw (33) until the Drive Belt
(23) is tight.
23
When the Drive Belt (23) is tight, tighten the M6 x
20mm Hex Screw (60).
Then, reattach the right shield, the right pedal, and the
top shield.
19
60
33