Table of Contents
Advertisement
Available languages
Available languages
Before You CaJt
Solutions
to Common
Problems
Before you calt for service, review this Hst, it may save you time and expense, The Hst incUudes common occurrences
that are not the resuUtof defective workmanship or materiaUs in this appliance,
OCCURRENCE
Range is not level.
POSSIBLE
CAUSE/SOLUTiON
Poor instaflation, PUaceoven rack in center of oven, PUacea bveU on the
oven rack, Adjust bvefing bgs at base of range until the rack is bveL When
range is bveL cooktop may appear out of alignment if countertop is not bveU
(See the Slide=in Installation Instructions),
Weak, unstable floor, Be sure floor is level and can adequately support range,
Contact a carpenter to correct sagging or sloping floor,
Kitchen cabinet misalignment may make range appear to be unbvel, Be sure
cabinets are square and have sufficient room for range clearance,
Cannot move appJiance easily.
AppJiance must be accessible
for
service.
Cabinets not square or are built in too tight, Contact a cabinet maker to
Contact builder or installer to make appliance accessible,
Carpeting interferes with range, Provide sufficient space so range can be
lifted over carpet,
Entire range or oven does not
operate.
Make sure cord/plug is tightly into outlet,
Service wiring is not complete, Call 1-800-4-MY-HOME®
(See
back cover).
Power outage, Check house lights to be sure, Call your local electric
company for service,
*Oven control beeps and displays
F1,
F2, F3 or Fg.
This oven is equipped with a state of the art electronic oven controller,
Among the many features is a full time oven circuit diagnostics system, The
controller constantly monitors the internal circuitry as well as several crucial
oven circuits to insure they are all operating correctly, If at any time one of
these systems fails, the controller will immediately stop the current operation
and beep continuously (flashing an error code of "F1, F2, F3" or "F9" in the
controflerdisplay
window,
Electronic control has detected a fault condition. Press STOP/CLEAR
to
clear the display and stop beeping. Reprogram oven. If fault remains, record
fault number. Press STOP/CLEAR
and call 1-800-4-MY-HOME®
(See back
cover),
Oven light does not work.
Burned-out or loose bulb, See "Replacing Oven Light" section in this Use &
Care Guide to replace or tighten the bulb(s),
Electrical power outage, Check house lights to be sure, Carl your local
electric company for service,
Surface burners
do not light.
Surface control knob has not been completely turned to LITE, Push in and
turn the surface control knob to LITE (until burner ignites) and then turn the
surface control knob to the desired flame size,
Burner ports are clogged, With the burner off, use a small-gauge wire or
needle to clean ports, See "Cleaning the Burner G rates, Burner Caps, Burner
Heads and Wok Stand" for additional cleaning instructions,
Gas supply is turned off, Turn gas supply on,
39
Advertisement
Table of Contents
