Maintenance; Oven Light; Oven Door; Door Lock Lever - Kenmore 30-inch electric wall ovens Owner's Manual

Before replacing light bulb, DISCONNECT POWER TO
OVEN. Be sure bulb is cool. Do not touch a hot bulb with a
damp cloth as the bulb may break.
To turn on the oven light: Push the rocker switch located
on the control panel.
To replace oven light: Be sure bulb is cool. Do not touch a
hot bulb with a damp cloth as the bulb may break. Use a dry
potholder, to prevent possible harm to hands, and very
carefully unscrew bulb cover and bulb. Replace with a 40
watt appliance bulb. Replace bulb cover and reconnect
power to oven. Reset clock.
i !i iili]i !iiiii!!ii!iii!iii!iiiiiii!!i!!ii!!iii!iii!
Do not place excessive weight on an open oven door or
stand on an open oven door as, in some cases, it could
cause the range to tip over, break the door or cause serious
injury to the user.
When opening the oven door, allow steam and hot air to
escape before reaching in oven to check, add or remove
food.
Do not attempt to open or close door until the door is
completely seated on the hinge arms. Never turn on the
oven unless door is properly in place. When baking, be sure
the door is completely closed. Baking results will be affected
if the door is not securely closed,
CAUTION: Hinge arms are spring mounted and will
slam shut against the range if accidently hit. Never
place hand or fingers between the hinges and the
front oven frame. You could be injured if hinge snaps
back.
ii ii i i!iiiiiii!i!i iiiiii!ii ii!iiiiii!iiiiiiiii!ii!iiiiiii
The oven door is locked for a self-clean operation only. Do
not move the door lock lever to the right or locked position
during a cooking operation, if the door is locked, the
operation will automatically be cancelled and "door" will
appear in the display. If the oven is hot enough to engage the
internal lock, the oven door will not open. Allow the oven to
cool for up to an hour, then unlock and open the door.
To remove lift-off door: Open the door to the "stop"
position (opened about 6 inches) and grasp the door with
both hands at each side. Do not use the door handle to lift the
door. Lift up evenly until the door clears the hinge arms.
To replace door: Grasp the door at each side, align slots in
the door with the hinge arms and slide the door down onto
the hinge arms until completely seated on hinges.