Kenmore 758.144161 Operator's Manual page 6

Water Fifl
WARNING: To reduce the risk of
shock, always unplug humidifier
before cleaning or servicing.
WARNING: To reduce the risk of fire
or shock hazard, do not pour or spill
water into control or motor area.
If controls get wet, Iet them dry
completely and have unit checked by
authorized service personnel before
plugging in.
This humidifier is designed to be filled
using a bucket fill method. The unit
should be positioned where it wilI be
operating. To filI the humidifier, close the
control cover and open the pivoting lid.
Notice the splash guard inside the
cabinet of the humidifier.
Use recommended mixture of cold water
and if necessary Sears Bacteriostat #32-
14900 only. Pour the water slowly from a
bucket into the cabinet onto the center of
splash guard.
NOTE: Deflect water off center of splash
guard when filling. The water deflects off
the spiash guard and drops into the
bottom of the cabinet. Do not pour water
onto top of unit or control area.
Standing in front of the humidifier, notice
the "FULL" labels positioned to the left
and right at the bottom inside of the
cabinet. These labels indicate the
maximum amount of water that can be
poured into the humidifier.
Do not fill water in the cabinet above
this line. If you do, water will Beak out
of the cabinet and onto the floor.
Pivoting Lid
Cabinet
Front of Humidifier