Kenmore 758.144161 Operator's Manual page 5

Location Instrucdons
WARNING: For your own safety, do
not use humidifier if any parts are
damaged or missing.
Step 1 :
Place humidifier on a flat level surface in
an area of your house where humidity is
needed most, or in an area which would
likely result in moist air being circulated
throughout the house, such as near a
cold air return.
Placing the unit level is very important if
the humidifier is located on carpeting.
Moist air (humidity) produced will
disperse into the whole house, but area
closest to the unit wilI have the highest
humidity. If the unit is positioned close to
a window, condensation may form on the
window pane. If this is not appropriate
the unit should be repositioned in another
location.
NOTE: Due to release of cool, moist air
from humidifier, it is best to direct air
away from home thermostat and hot air
registers. It is best to position humidifier
next to an inside walk Hot air registers
and cold air from outside walls can affect
the efficiencies of the controls. Unit
should not be placed where warm air
from a hot air register blows directly on
unit.
Step 2:
The humidifier should be positioned with
the back (cord exit side), at least 2
inches away from the wall. Air needs to
enter through the louvers in the rear
panel in order for the humidifier to
operate at peak efficiency.
At Least 2" From WaSI
Eiectrical Hook-Up
Locate nearest 120V A.C. wall socket in
the location desired, preferably on inside
wail. With the humidifier in the desired
location, route the electrical cord safely
so no one wilI trip or upset the humidifier.
Plug in the electrical cord.
WARNING: To reduce the risk of fire
or shock hazard, humidifier should
be plugged into a 120V A.C. outlet.
Do not use extension cords.
To reduce the risk of electrical shock, this
humidifier has a polarized plug (one
blade is wider than the other)+ This plug
will fit in a polarized outlet only one way.
if the plug does not fit fully in the outlet,
reverse plug. if it still does not fit, contact
a qualified electrician to instalI the proper
outlet. Do not change the plug in any way.